Niagara Cutter N88628 Cobalt Steel Square Nose End Mill, inch, Weldon Shank, TiCN Finish, Finishing Cut, 30 Degree Helix, 4 Flut

Description

Cutting diameter tolerance is +0.001” to -0.000”. Specializing in end mills, cutting mills, and saws, the company is based in New York and manufactures its tools at facilities in Pennsylvania and Massachusetts. The number of flutes can range from two to eight. It balances lower angles’ strong cutting edge for difficult-to-machine materials with higher angles’ increased cutting action. The Niagara Cutter SPC408 TiCN-coated cobalt steel square nose end mill has a 30-degree helix angle for milling a wide range of materials, including high-temperature alloys. Two-flute designs offer the most efficient chip removal, but more flutes provide a smoother finish. Center-cutting end mills can create three-dimensional shapes and profiles, and make plunge cuts similar to a drill bit. The end mill has a Weldon shank. The number of flutes varies; fewer flutes provide better chip-carrying capacity, while more flutes produce a finer finish. End mills are designed to remove material and create multi-dimensional shapes and profiles. The tool’s square end has straight cutting edges that create sharp, unrounded cuts, while the center-cutting design has cutting teeth at the end of the tool that support making pocket cuts, profiling, and slotting. If heat is not reduced effectively, the tool’s cutting edges will dull and additional material buildup can occur. The shank is the end of the tool held in place by a tool holder or machine. The 30-degree helix angle supports general-purpose applications.

Key Features

• The cobalt steel substrate can be run at faster speeds and stays sharp longer than high-speed steel tools, while offering greater resistance to heat and abrasion.
• The tool’s square end has straight cutting edges that create sharp, unrounded cuts, while the center-cutting design has cutting teeth at the end of the tool that support making pocket cuts, profiling, and slotting.
• The Niagara Cutter SPC408 TiCN-coated cobalt steel square nose end mill has a 30-degree helix angle for milling a wide range of materials, including high-temperature alloys.
• The 30-degree helix angle supports general-purpose applications.
• The number of flutes varies; fewer flutes provide better chip-carrying capacity, while more flutes produce a finer finish.
• End mills are designed to remove material and create multi-dimensional shapes and profiles.